DIY Friday: Silver Beaded Bracelet with Tassel

I know that most of you will be hitting the malls tomorrow in full combat gear, but if you decide to stay home and want to try your hand at making something (instead of buying something) why not try this simple silver beaded bracelet with tassel?  I wanted something delicate that I could layer with my other silver pieces and thought these small, silver plated beads would be perfect. And the tassel? It's there for a bit of pizazz and color.

You will need:

- silver beads

- elastic cord

- embroidery thread in multiple colors

- scissors

Step 1: 

Measure your wrist with doubled elastic cord, leave extra room for tying. Fold elastic in half (doubling) and start stringing beads onto the cord.  Doubling up on the cord does take a little extra stringing time but it's worth the added security and strength.

Step 2:

Continue stringing beads until you have enough to encircle your wrist.  Tie a double knot (pulling tightly) and snip your ends.

Step 3:

Cut 2 inches of embroidery thread in each color. Fold them in half over the knot. Take another 2 inch strand and tie around the thread (double knot) at the top.  Trim the ends.

 Ta Da!

I frayed the ends a little more by separating the thread for a fuller look. Then I paired it with another silver bracelet to complete the look.  

 Stay tuned for a DIY on the floral, crystal bracelet I made (wearing above) next Friday!

DIY Friday: Three Bead Wire Bracelet

This is a fun little DIY with very few steps. If you're in a hurry, or just have a short attention span, this DIY is for you. And 5 minutes later you'll have a pretty, dainty new bracelet for your arm party.

You will need:
- Thick silver wire
- 3 silver colored beads
- Snips
- Round nose pliers

Step 1: Measure out how much silver wire you'll need for your bracelet and cut. Remember to leave a little extra because the ends will be curled around.

 Step 2: Using the round nose pliers, curl one end of the wire around forming a closed loop.

Step 3: String 3 beads onto the uncurled end.

Step 4: Re-measure your bracelet and snip excess chain (if you have some. I did.)

Step 5: Curl the other end of the bracelet around the round nose pliers in the opposite direction of the first end. Don't curl completely, leave an opening as this will serve as your clasp. The open end will fit into the closed end easily.

The end result:

Will you be trying this DIY bracelet this weekend? If not, what plans do you have for the weekend? Have a great time!